Rod clamp
A clamp ring for rods and arms: holds window stay arms, telescopic rods or roof vents in position. Tighten with an M3 or M4 screw.
STL + 3MFExport
0 €Cost
in browserRuns
How it works
Enter the rod diameter. The ring wraps the rod and is tightened with a screw through the ears.
As a stop on a window arm it keeps the window from opening further. It does not replace burglary protection.
Printing notes
- Print upright with the opening facing up, no supports.
- Do not overtighten the screw, PETG flexes, PLA can crack.
- For moving, loaded parts metal clamps are the better choice.
Common questions
Which screw fits?
M3 for small rods up to about 12 mm, M4 for larger. The nut sits in the hex pocket.
Does the clamp hold permanently?
For light uses yes. PLA can give in with heat, use PETG or ASA.