Pipe & hose adapter
Join two diameters: vacuum hose, dust extraction, ducting or aquarium. Each end plugs in or slips over.
STL + 3MFExport
0 €Cost
in browserRuns
How it works
Enter the diameter for each end and choose whether it plugs into a pipe or slips over one.
For a plug the value is the adapter outside diameter, for a sleeve it is the outside diameter of the pipe it covers.
Printing notes
- Print upright on the larger end.
- PLA is fine for airflow. For warm air above 50 °C use PETG or ASA.
- Barbs grip hoses but make removing them harder.
Common questions
How do I measure a hose?
For a plug measure the inside diameter and subtract 0.2 mm. For a sleeve measure the outside diameter.
Is it airtight?
Good for air and dust. Not intended for pressurised water.