Phone Stand
A stand for phone, tablet or e-reader: set device thickness, angle and width, with a cable hole for charging.
STL + 3MFExport
0 €Cost
in browserRuns
How it works
Enter the thickness of your device including case, choose the tilt angle and the width. The device stands on the base, leans on the back plate and is held at the front by a lip.
The cable hole lets you charge the device while it stands.
Printing notes
- Print upright as the model stands, without supports.
- PETG or PLA with 3 walls and 20 % infill so the stand can carry a tablet.
- A strip of rubber or felt underneath prevents sliding.
Common questions
Which thickness?
Measure the device with case at its thickest point and add 1 to 2 mm. Phones are usually 9 to 14 mm, tablets 8 to 12 mm.
Which angle is good?
About 65 to 75 degrees for phones on a desk, flatter for tablets for typing.