Pegboard Hooks
Hooks and shelves for pegboards: set hole pitch, peg size and reach, download STL or 3MF.
STL + 3MFExport
0 €Cost
in browserRuns
How it works
Measure the distance between two holes and the hole diameter of your pegboard. The generator places two pegs at the right spacing on a hook or shelf.
The holder prints on its side so the layers run along the load.
Printing notes
- Print lying on its side, no supports. The pegs need a clean first layer.
- PETG, 4 walls, 40 % infill for tools.
- If the peg is too tight in the hole, reduce the diameter by 0.1 mm.
Common questions
Which hole pitch?
Many pegboards use 25 mm or 1 inch (25.4 mm), some 38 mm. Measure centre to centre of two holes.
Does it hold firmly?
It wedges in the hole. A drop of glue or a clip on the peg adds hold.