Cable Clip Generator
Cable holders for one to eight cables: enter the cable diameter, choose opening and mounting, download STL or 3MF.
STL + 3MFExport
0 €Cost
in browserRuns
How it works
The clip holds cables on a desk, wall or the back of furniture. The cable diameter sets the ring size and the opening on top lets you snap the cable in.
Choose countersunk screw tabs or a flat underside for double-sided tape.
Printing notes
- Print flat with the rings pointing up, no supports needed.
- PETG or TPU flex better than PLA and are less likely to snap.
- If the clip is too tight, add 0.2 mm to the cable diameter.
Common questions
How thick is a USB cable?
Most USB cables are 3 to 4.5 mm, power cables 6 to 8 mm, HDMI about 6 mm.
Does it hold well?
Very well with screws. For tape, use good mounting tape and clean the surface first.